How to remove the servos

This article explains how to remove the servos from WingtraOne in case they are needed back for investigation.

Detailed step-by instructions can be found in the video below:

Required tools:

1. Make sure WingtraOne is not powered. Lay it on a flat surface

2. Losen the screw which goes into the drive shaft of the servo

3. Before completely unscrewing - hit the Allen Key ( or better a T10 screw-driver ) with a hammer or similar to loosen the screw locking adhesive

4. Open the e-cover and remove all cables close to the servo

5. Try to remove the servo.

6. Either unplug the servo's connector or cut it