How to move the RX1 camera to a GEN II mount

Find in this article the step-by-step instructions on how to remove an RX1 camera from a WingtraOne GEN I RX1 mount and insert it in a WingtraOne GEN II compatible mount.

Step-by-step instructions

Step 1 Remove the RX1RII camera attached to the mount from WingtraOne

Step 2 Remove the RX1RII from the mount

Step 3 Insert the CCU clip in the RX1 camera

The CCU clip is shipped together with the GEN II RX1 mount and it should be placed in the camera before it is inserted into the mount. 

Step 4 Place the RX1RII into the GEN II mount

Step 5 Place the RX1RII attached to the new mount into WingtraOne GEN II

• Use the Torx screwdriver to tighten the four screws in the four corners of the payload area.
• Plug the USB-C universal payload connector into the drone.
• Close the top cover.
• Do a test flight.